Hidden Fixings:
Millboard uses their small headed stainless screws called Durafix. There’s no pre-drilling or countersinking needed. You can simply screw through the surface of the board and thanks to the flexible Lastane® surface the screw disappears below the surface leaving virtually no mark and creating a really clean finish.

To be used for Deckboards 4.5 x 60mm Durafix Stainless Steel Screws

Approx number of screws required is 22 per board

Touch Up Coating:
This is a coating that can be used to blend in any cut ends. There are seven different colours that will match with your deckboards.

We would advise to finish off your decking area with Millboards matching Fascia & Edging however depending on your project you can use this coating on any exposed ends. Please note any ends will turn yellow when exposed to UV light/Sunlight so we would advise coating all exposed ends.

Cutting:
The boards can be cut with standard saw blades, although Millboard recommend a carbon-tipped, multi-purposed chop saw. As the formed end of the moulded board should be squared up and trimmed off this can either be placed in a less visible area or touched up with the matching paint. Using the matching fascia and edging boards will add a more professional finish. Please note Millboard offcuts cannot be burnt and have to be sent to landfill sites.